Reception Ferrotungsten from Wolframite Concentrate by Alumimotermic Method

Authors

  • N. Yu. Golovchenko Al-Farabi Kazakh National University, av. al-Farabi, 71, Almaty, Republic of Kazakhstan
  • O. S. Bairakova Institute of Combustion Problems, Bogenbay batir str., 172, Almaty, Republic of Kazakhstan
  • G. I. Ksandopulo Institute of Combustion Problems, Bogenbay batir str., 172, Almaty, Republic of Kazakhstan
  • S. Kh. Aknazarov Al-Farabi Kazakh National University, av. al-Farabi, 71, Almaty, Republic of Kazakhstan

DOI:

https://doi.org/10.18321/ectj86

Abstract

For the smelting ferrotungsten of raw materials (mineral) took us to calculate the charge for each experiment. To optimize the process of obtaining ferrotungsten of wolframite carried out the following
activities: to reduce speed and combustion temperature. A change batch positive impact on the development of the combustion process. Experimental results have shown the effectiveness of the introduction of aluminium additives in excess of stoichiometry because the explosive burning regime turned into stationary. In this work the charge calculated on 300 g volframite concentrate so that as a result of the aluminotermic reaction in the alloy contained 70% of tungsten. Calculations of charge showed that in the case of the smelting of ferro-alloys and master alloys used in this work and have a high melting point (ferrotungsten, ferromolybdenum, etc.) – temperature process of melting alloy is indispensable for the success of melting. To reduce the speed of combustion and the temperature were conducted experiments on selection of ballast additives which allows you to bring the process to a smooth flow of the reaction. As ballast additives used aluminium oxide. It was found that an increase of more than 20 additives reducing the release of the alloy and metal extraction. Also included experiments on selection of warm additives. Use as a warm additive of ammonium nitrate is not desirable because of the rapid reaction and loss of metal slag. The output and the extraction of metal in the application of potassium and sodium nitrate are the same but in the case of kalievoj nitrate slag can be used as a prolonged potash fertilizer. From the X-ray spectrometer alloys were analyzed.

References

1. Zelikman A.N., Nikitin of h.p. Tungsten. М: Metallurgy, 1978, 272 s.

2. Gotman P. E, Berezin V. B, Khaikin A.M. Electrochemical materials. The directory. М:Energy,1969, 544 p.

3. K.Dzh. Smitells. Tungsten. The lane with English 1958, 414 p.

4. Levashov E.A., Rogachev A. S., Yuhvid V. I., Borovitskaya I. P. Physical and chemical bases of self preparating high temperature synthesis М.: ZAO «Binom», 1999, 175 p.

5. SHS-2011 XI International Symposium of Self-Propagating High Temperature Synthesis, 2011/ Golovchenko N., Bayrakova O., Ksandopulo G.I., Aknazarov S.Kh. Reception Ferrotungsten from raw materials with low content of tungsten scrap under pressure, p. 240.

6. Merjanov A.G. Process of burning in physicochemistry and technologies of inorganic materials. Successes of chemistry. Т. 72, №4 2003, p. 323-339 (342).

7. Merzhanov A.G. Self-propagation hightemperature synthesis: twenty years of search and findings // Combustion and plasma synthesis of high-temperature materials. - 1990, P. 1-54.

8. Orru’ R., Sannia M., Cincotti A., Cao G. Treatment and recycling of zinc hydrometallugical wastes by self-propagating reactions // Chemical Engineering Science. –1999, Vol. 54, Р. 3053-3061.

9. GOST 2211-94, IUS 992.

10. Sata N., Hirano T., Niino M. Fabrication of functionally gradient material by using a selfpropagating
reaction process // Combustion and plasma synthesis of high-temperature materials. – 1990, Р.195-203.

11. Ksandopulo G.I, Bajdeldinova A.N., Bajrakova O. S. Features of technological process of melt of noble ferroalloys in small metallurgy // XXI-st century Metallurgy - a condition and development strategy. Works of the international conference, Almaty, Kazakhstan. - 2006. - P. 114-118.

12. Pliner J.L., Dubrovin А.С. About speed of processes aluminotermic restoration. М: Metallurgy and mining, 1964.

13. ISSN 0967-0912, Steel in Translation, 2009, Vol. 39. L.I. Leont’ev, V.M. Rytvin, S.I. Gil’varg, V.A. Perepelitsyn, V.A. Rovnushkin, 2009, published in “Stal’,” 2009, No. 4, pp. 72–75.

Downloads

Published

2011-12-22

How to Cite

Golovchenko, N. Y., Bairakova, O. S., Ksandopulo, G. I., & Aknazarov, S. K. (2011). Reception Ferrotungsten from Wolframite Concentrate by Alumimotermic Method. Eurasian Chemico-Technological Journal, 13(3-4), 205–212. https://doi.org/10.18321/ectj86

Issue

Vol. 13 No. 3-4 (2011)

Section

Articles

License

You are free to: Share — copy and redistribute the material in any medium or format. Adapt — remix, transform, and build upon the material for any purpose, even commercially.

Eurasian Chemico-Technological Journal applies a Creative Commons Attribution 4.0 International License to articles and other works we publish.

Subject to the acceptance of the Article for publication in the Eurasian Chemico-Technological Journal, the Author(s) agrees to grant Eurasian Chemico-Technological Journal permission to publish the unpublished and original Article and all associated supplemental material under the Creative Commons Attribution 4.0 International license (CC BY 4.0).

Further distribution of this work must maintain attribution to the author(s) and the published article’s title, journal citation, and DOI.