Nitric Oxide Pathways in Surface-Flame Radiant Burners
DOI:
https://doi.org/10.18321/ectj179Abstract
Nitrogen oxide (NOx) formation in surface-flame burners is studied. Surface-flame burners are typically made of metal fibers, ceramic fibers, or ceramic foam and provide radiant flux with low pollutant emissions. A one-dimensional model represents combustion on and within the porous medium using multistep chemistry, separate gas and energy equations, and a radiatively participating porous medium. We describe experimental measurements of NOx profiles above a surface-flame burner and compare them to model predictions. The model predicts NOx concentration with reasonable success. Deviations between model and experiment are primarily the result of heat loss in the experiment that is not considered in the model. Reaction rate analysis is performed to identify the chemical kinetic source of NO in the flame. Zeldovich NO is significant only at the highest firing rate studied (600 kW/m2, ϕ = 0.9), where it is responsible for 50-60% of the total NO. At the lower firing rates (200 and 300 kW/m2, ϕ = 0.9), where total NO is low, nearly all of the NO is formed in the flame front. Zeldovich NO accounts for 20-30% percent of the total NO, the Fenimore pathway accounts for less than 10% of the NO, and 50-75% percent of the NO is formed through the NNH, N2O and other paths. Sensitivity analysis shows that NO production in the flame front is most sensitive to NNH+O = NH+NO, with CH+N2 = HCN+N having the second highest sensitivity coefficient. At the lower firing rates NO emission is insensitive to porous medium properties, while at the high firing rate NO emission is slightly sensitive to porous medium properties.
References
[2]. P. Mattsson, J. Pelkonen, A. Riikonen, and N. Oy, Paperi ja Puu–Paper and Timber 72 (1990) 347–349.
[3]. S. Singh, M. Ziolkowski, J. Sultzbaugh, and R. Viskanta, in Fossil Fuel Combustion (R.Ruiz, Ed.), 1992, ASME PD-33, p. 111.
[4]. F. Andersen, Prog. Energy Comb. Sci., 18 (1992) 1–12.
[5]. Y.-K. Chen, R.D. Matthews, and J.R. Howell, in Radiation, Phase Change Heat Transfer and Thermal Systems (Y. Jaluria et al., Ed.), 1987, ASME HTD- 81, p. 35.
[6]. S.B. Sathe, R.E. Peck, and T.W. Tong, Int. J. Heat Mass Transfer 33 (1990) 1331–1338.
[7]. P.H. Bouma, R.L.G.M. Eggels, L.M.T. Somers, L.P.H. de Goey, J.K. Nieuwenhuizen, and A. Van Der Drift, Combust. Sci. Technol. 108 (1994) 193-203.
[8]. M. Kulkarni, Ph.D. dissertation, Arizona State University, 1996.
[9]. P.-F. Hsu, W.D. Evans, and J.R. Howell, Combust. Sci. Technol. 90 (1993) 149-172.
[10]. J.D. Sullivan, and R.M. Kendall, International Gas Research Conference, Orlando, Florida, 1992.
[11]. A. Williams, R. Woolley, and M. Lawes, Combust. Flame 89 (1992) 157–166.
[12]. A.V. Mokhov, and H.B. Levinsky, 26th Symp. (Int.) Combust., The Combustion Institute, Pittsburgh, 1996, pp. 2147–2154.
[13]. J.A. Miller, and C. T. Bowman, Prog. Energ. Combus. Sci. 15 (1989) 287–338.
[14]. R.J. Kee, J.F. Grcar, M.D. Smooke, and J.A. Miller, (1985), A Fortran Program for Modeling Steady Laminar One-Dimensional Premixed Flames, Sandia National Laboratory, SAND85-8240.
[15]. M.D. Rumminger, N.H. Heberle, R.W. Dibble, and D.R. Crosley, 26th Symp. (Int.) Combust., The Combustion Institute, Pittsburgh, 1996, pp. 1755–1762.
[16]. M.D. Rumminger, Ph.D. dissertation, University of California, Berkeley, 1996.
[17]. R.J. Kee, F.M. Rupley, and J.A. Miller, (1989), CHEMKIN-II: A Fortran Chemical Kinetics Package for the Analysis of Gas Phase Chemical Kinetics, Sandia National Laboratory, SAND89-8009B.
[18]. R.J. Kee, G. Dixon-Lewis, G. Warnatz, M.E. Coltrin, and J.A. Miller, (1986), A Fortran Computer Package for the Evaluation of Gas-Phase, Multicomponent Transport Properties, Sandia National Laboratory, SAND86-8246.
[19]. J.F. Grcar, (1992), The Twopnt Program for Boundary Value Problems, Sandia National Laboratory, SAND91-8230.
[20]. M. Golombok, A. Prothero, L.C. Shirvill, and L.M. Small, Combust. Sci. Technol. 77 (1991) 203–223.
[21]. R. Mital, J.P. Gore, and R. Viskanta, (1995), AIAA Paper No. 95–2036.
[22]. W.J. Mantle, and W.S. Chang, J. Thermophys. Heat Transfer 5 (1991) 545–549.
[23]. M.G. Semena, and V.K. Zaripov, Thermal Engineering 24 (4) (1977) 69–72.
[24]. R.M. Kendall, S.T. DesJardin, J.D. Sullivan, (1992), Basic Research on Radiant Burners, Gas Research Institute Report number 92-7027-171.
[25]. S. Yagi, D. Kunii, and N. Wakao, AIChE J. 6 (1960) 543–546.
[26]. C.T. Bowman, R.K. Hanson, W.C. Gardiner, V. Lissianski, M. Frenklach, M. Goldenberg and G.P. Smith, “GRI-Mech 2.11 - An Optimized Detailed Chemical Reaction mechanism for Methane Combustion and NO Formation
and Reburning,” GRI-Report GRI-97/0020, March 1997.
[27]. Y.B. Zeldovich, Acta Physiocochemica USSR, 21: 577 (1946).
[28]. C.P. Fenimore, 13th Symp. (Int.) on Combust., The Combustion Institute, Pittsburgh, 1970, pp. 373–380.
[29]. J. Wolfrum, Chemie Ingenieur Technik, 44: 656 (1972).
[30]. P.C. Malte, and D.T. Pratt, Combust. Sci. Tech., 9:221 (1974).
[31]. J.W. Bozzelli, and A.M. Dean, Int. J. Chem. Kinet. 27 (1995) 1097–1109.
[32]. R.C. Flagan, and J.H. Seinfeld, Fundamentals of Air Pollution Engineering. Prentice-Hall, Inc., Englewood Cliffs, NJ, 1988.
[33]. A. Schlegel, S. Buser, P. Benz, H. Bockhorn, and F. Mauss, 25th Symp. (Int.) on Combust., The Combustion Institute, Pittsburgh, 1994, pp. 1019–1026.
[34]. P.A. Berg, G.P. Smith, J.B. Jeffries, and D.R. Crosley, 27th Symp. (Int.) on Combust., The Combustion Institute, Pittsburgh, 1998, pp. 1377–1384.
[35]. V. Sick, F. Hildenbrand, and P. Lindstedt, 27th Symp. (Int.) on Combust., The Combustion Institute, Pittsburgh, 1998, pp. 1401–1409.
[36]. S. Singh, Personal communication, January 1996.
Downloads
Published
How to Cite
Issue
Section
License
You are free to: Share — copy and redistribute the material in any medium or format. Adapt — remix, transform, and build upon the material for any purpose, even commercially.
Eurasian Chemico-Technological Journal applies a Creative Commons Attribution 4.0 International License to articles and other works we publish.
Subject to the acceptance of the Article for publication in the Eurasian Chemico-Technological Journal, the Author(s) agrees to grant Eurasian Chemico-Technological Journal permission to publish the unpublished and original Article and all associated supplemental material under the Creative Commons Attribution 4.0 International license (CC BY 4.0).
Further distribution of this work must maintain attribution to the author(s) and the published article’s title, journal citation, and DOI.