Non-Catalytic NOx Removal from Gas Turbine Exhaust with Cyanuric Acid in a Recirculating Reactor; Small Scale Evaluation and Industrial Application
DOI:
https://doi.org/10.18321/ectj180Abstract
A novel SNC technique to remove oxides of nitrogen (NOx) from stationary gas turbine exhaust has been investigated and applied. The technique employs the use of cyanuric acid (CYA), a non-toxic, dry powder, combined with the injection of auxiliary turbine fuel and recirculation. During the initial investigation, exhaust, generated by a 150 kW gas turbine, was treated in an insulated recirculation reactor, with a mean residence time of 0.65 to 0.71 seconds and a pressure drop of 660 Pa. In the reactor, autoignition of injected auxiliary gas turbine fuel raises the flue gas temperature to between 700 and 800 ºC. CYA slurry is injected. Temperature rise and NOx reduction occur simultaneously. Load following has been achieved. At all temperatures, significant NOx reduction from initial concentrations of 106 to 124 ppm to as low as 18 ppm at 15% O2 have been observed. However, The process generates N2O emissions, which vary from 45 to 163 ppm, increasing with increasing CYA/NOx ratio. The ratio of N2O formed to NO removed was found to be between 1 to 1.5 to 1. The performance of CYA ((HNCO)3) is compared to that of ammonia (NH3) and urea ((NH2)2CO). A numerical model, which combines a detailed chemical kinetic mechanism with recirculation, has been developed. The model captures all observed trends well and is an invaluable guide to improved understanding of the interactive NOx removal process. The process was then successfully scaled up and applied to a variety of industrial 3.7 MW gas turbines and similarly significant NOx reduction has been achieved.
References
[2]. H.S. Rosenberg et al. “Post Combustion Methods for Control of NOx Emissions” Prog. Energy Combustion Sci. 6 (1980) 287–302.
[3]. R.K. Lyon, “Method of the Reduction of the Concetration of NO in Combustion Effluents Using Ammonia”, U.S. Patent 3,900,554, 1975.
[4]. J.K. Arand, L.J. Muzio, and J.G Sotter, “Urea Reduction of NOx in Combustion Effluents”, U.S. Patent No. 4,208,386, 1982.
[5]. R.A. Perry and D.L. Siebers, Nature, 324 (1984) 657–658.
[6]. D.L. Siebers and J.A. Caton, Combust. Flame 79 (1990) 31-46.
[7]. L.J. Muzio and J.C. Kramlich, “Potential Errors in Grab Sample Measurements of N2O from Combustion Sources” Western States Section, The Combustion Institute, Fall 1988.
[8]. R.A. Perry, “Application of RAPRENOx to Diesel Emission Control” Technology Assessment and Research program for Offshore Minerals Operations, U.S. Department of the Interior Minerals Management Service, DOI
No. 85K-SC293V, pp 185-190, 1991.
[9]. C.K. Westbrook and W.J. Pitz “A Comprehensive Chemical Kinetic Reaction Mechanism for Oxidation and Pyrolysis of Propane and Propene” Combustion, Science and Technology, Vol. 37, 1984.
[10]. J.A. Miller and R.A. Perry, Int. J. Chem. Kinet. 28 (1996) 217–234.
[11]. L.J. Muzio, T.A. Montgomery, G.S. Samuelsen, J.C. Kramlich, R.K. Lyon, and A. Kokkinos, “ Formation and Measurement of N2O in Combustion Systems” 23rd Symp. (Int.) Combust., The Combustion Institute, pp. 245-
250, 1990.
[12]. A.R. Mosier, and L. Mack, Soil Sci. Soc. Am. J., 44 (1980) 1121–1123.
[13]. M. Elsener, and M. Koebel, ”Analyse von Isocyansaeure, Blausaeure, Ammoniak und Lachgas in den Abgasen von Entstickungsprozessen”, [Analysis of HNCO, HCN, NH3 and N2O in Effluents from NOx Reduction
Processes], Paul Scherrer Institut (Verbrennungstechnik), Reg. No. TM-51-89-21, Jul. 1989.
[14]. R.A. Perry, “Application of RAPRENOx to NOx Control in Diesel Generators”, First Int. on Combustion Technologies for a Clean Environment, Lisbon, Portugal, 1991.
[15]. M. Streichsbier, R.W. Dibble, and R.A. Perry, “Non-Catalytic NOx Removal from Gas Turbine Exhaust with CYA in a Recirculating Reactor”, AIChE, Proceedings of the 1997 Annual Meeting, Paper No. 256a, 1997.
Downloads
Published
How to Cite
Issue
Section
License
You are free to: Share — copy and redistribute the material in any medium or format. Adapt — remix, transform, and build upon the material for any purpose, even commercially.
Eurasian Chemico-Technological Journal applies a Creative Commons Attribution 4.0 International License to articles and other works we publish.
Subject to the acceptance of the Article for publication in the Eurasian Chemico-Technological Journal, the Author(s) agrees to grant Eurasian Chemico-Technological Journal permission to publish the unpublished and original Article and all associated supplemental material under the Creative Commons Attribution 4.0 International license (CC BY 4.0).
Further distribution of this work must maintain attribution to the author(s) and the published article’s title, journal citation, and DOI.